If you have a dog that likes to bark, and especially if your dog loves to play in the backyard and other areas of the home, you need to get them some special dog protection.
Paper Plate 3d Dog Mask DIY Materials: This is the first part of the set-up that will look a little scary at first, but it’s really very simple. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can’t simply cut a rectangular shape from the cardboard, so you will need to cut around the edge of the mask so that you get something that resembles a cone. The most important thing here is to be realistic with what type of paper plate which you’re using.
Then you’ll need to wrap the cardboard around the edges of the paper plate, making certain that there is a good seal between the two pieces so you can make certain that nothing will leak when you place the mask on. Make sure the edges are cut so the edges aren’t sharp, as this may damage the edges of the mask.
Glue it on! The next step involves using some paint. You should spray the paint over the cardboard, making certain it runs smoothly and evenly across the entire mask. You will want to start with one side of the mask first, so that you can work your way around it before moving onto the other side. The paint needs to be slightly thicker than the cardboard, and it is best that you leave about one-fifth of an inch of paint on the edges so that it runs across the cardboard.
Don’t fret too much about the paint getting stuck to your mask. It’s easy to remove it later, and it’ll leave you with a wonderful finished mask to show off to everybody! It’s also a good idea http://alzaracupping.com/the-best-affordable-dog-food-finding-the-right-type-of-cheap-dog-food/ to wash away any excess paint after you are done, so that you don’t end up with smudges or smears on your dog.
Then it’s time to paste the mask onto your dog’s head. First you will need to be certain that you have a secure fit between the mask and your dog’s head. Once you’ve made sure that it’s secure, then you can begin to glue the mask onto the dog’s face. Take the piece of cardboard that is used for the foundation of the mask and then fold it over. Be sure that it’s quite powerful and then use your hands to secure the cardboard down in place.
Keep your hands out of the way and use tape to hold it in place as you repeat the process on the cardboard folds until you’ve got the mask snugged securely onto the surface of your dog. Don’t make the folds too big or else it could look messy. Once you’ve done this, you can then take out the mask and then attach the cardboard ears. And attach the other area of the mask onto the dog. Make certain the ears are flat and be certain it is not too short or long as this can cause some problems with the mask slipping off the dog’s face.
If you’re using a dog mask because your dog protection, you’ll need to do some sanding to be sure that it’s safe on your dog. You can accomplish it by sanding off any excess paper that may have been eliminated from your mask.